How to Strengthen the Signal Router

Make your home router let me share internet use can be used as a family or a joint venture with internet plug

Here are some tips to amplify the signal router. Moreover, some of this week again booming TP-Link Wireless N Router 3G/3.75G TL-MR3420/TL-MR3220, to spread internet access which is obtained from the USB Modem ..

How to strengthen the signal ROUTER!
Basically the wireless router has a range of 100 feet or more, but there are many factors that can make the range is reduced, making the signal and the signal strength is reduced from that you banyangkan. Interference can be caused by metal, other signals and other electronic devices that use wireless frequencies like cell phones and microwave ovens. There are many methods you can use to amplify the signal strength.

Step 1 Check the interference (noise)

Move the device in your home that may cause network traffic to track the frequency of 2.4GHz. These devices include cordless phones, microwave ovens, and the like.
Check the signal strength by turning on and turning off these devices to determine if it causes interference signal.
Purchase a wireless network analyzer to find out the source of interference.

Step 2 Change the channel your signal

Routers can broadcast on several series of channels, between one to eleven. Change the channel that your router will provide a clean signal between the wireless networks available.
Use a software utility to analyze which networks are using a channel.
Arrange your system to use an unused channel.

Step 3 Position Reset Your Router

Position as high as possible to increase the effectiveness of broadcast range.
Place in the center of the house or room for a wider range.
Position as close to the receiver.
Keep away from metal items including metal shelving, filing cabinets and the like goods.
Keep away from wireless devices like cell phones, cordless phones, microwaves, which operate at 2.4-GHz frequency.
Keep as far away from Wi-Fi routers that are near your location (Surely you must make sure that you use a different channel).

Step 4 Raise your Transmit Power

Check your router documentation and configuration utility to change the Xmit power of your router: Number of power used to transmit the signal. Generally, you can increase this figure to over 50mW, but beware of the risk of overheating or damage to your router.


Step 5 Replace Antenna

Remove and replace the broadcast antenna on your router with a model that can provide more power. Not all routers can be replaced antennanya, but most can.


Step 6 Install Repeater

This way the most my recommendation. Buy a Repeater. A repeater is a hardware device that served as a wireless network pemekar. Repeaters take the signal from your router and push the signal to increase the distance.


Step 7 Install Wireless Amplifier

Purchase and connect a wireless amplifier (also known as the booster) directly into your router. A booster may be more effective than repetaer which only increases the signal strength that already exists, rather than increasing the strength and distance.

source : http://livebeta.kaskus.us/thread/000000000000000006396602/share---pengguna-router-tp-link-tl-mr3420-tl-mr3220-share-disini