Faster Detect Modem in Router TP-LINK TL-MR3420

When I first pake constraint this modem which I feel is the modem was hard to detected by the TPLINK(although bin file is correct). Because of that, not a few who pull the plug the modem continues to hope that didetect In my opinion, to pull the plug in vain as it actually exacerbates the ability to detect tplink EC1261-2 is.

A little of my solution, if one day the same modem was detected not tplink (unknown modem), how is the bin file delete Network> 3G then Delete All. Bin file after it is clean. TPLINK turn off (by pulling out the power cable, I do not know anymore how to switch off but unplug the cable). Unplug the modem, wait a few seconds then on again a new bin upload the file again. After the bin file was uploaded plug the modem, then reboot the tplink. Usually the modem can be detected within a period of 5-10 min's, more than that it's mean can't be detected . If it still can't be detected also, unplug the power cable (without unplugging the modem) wait a few seconds a new plug in again. In this condition the modem should have been easy detected by the tplink.

Conclusion: The key is to never disconnect the modem when tplink flame again. Unplug the modem only when conditions are tplink dead. And if you do not accidentally disconnect fitting tplink flame again, erase bin file then upload them again (order as above)
Until now so I keep the modem connection is always faster

Source : http://livebeta.kaskus.us/thread/000000000000000006396602/share---pengguna-router-tp-link-tl-mr3420-tl-mr3220-share-disini